Camerapedia
Advertisement

See the Category: 120 film for a list of cameras using this film.

120 film is a film format for still photography introduced by Kodak for its Brownie No. 2 in 1901, and is still very popular, as the surviving medium format. Its specifications are defined by ISO 732; most recently (as of 2006), by ISO 732:2000.

The 120 format was originally intended for amateur photography, and actually became the main format for beginners' cameras, especially for box cameras. It was later superseded in this role by 35mm film and cartridge films (such as 126). 120 film became a format just for professionals and more ambitious amateurs, also revived for fads such as that for the Holga.

In Japan, 120 film was normally called "Brownie film" (ブローニーフィルム; Burōnī firumu) film until about the 1950s, because it was associated with the Brownie camera. Thus the Bronica, named after the film size, is indirectly named after the Brownie. At the same time, the 6×4.5 format was called Semi (セミ; Semi) and the 6×6 format was called Six (シックス; Shikkusu).

A120 or Autographic 120 film was produced by Eastman Kodak from 1914 to 1934.

Characteristics[]

120 is a typical roll film format. The spool was originally made of wood with metal flanges, later all metal, and finally plastic. The film strip is fixed to the backing paper at its leading end but is free at the other. The paper strip is much longer than the film strip. Thus the film is always wrapped light tight in paper before insertion into a camera or film back, and also after removal for development. The backing paper is black, or at least one side of it is blackened to render it completely opaque. In most designs until the 1950s, as well as cheaper cameras to the present day, a red window in the camera back is used for exposure counting (via a hole in the film pressure plate).

Frame numbers for the main frame formats (4.5×6, 6×6, 6×9) are printed on the back of the backing paper. The three series of numbers did not appear at once: at the beginning only the '1' to '8' numbers for 6×9 format were present, and this explains why the very first Rolleiflex models used not 120 but 117 film, specifically designed for 6×6, and why the first 4.5×6 cameras like the Ikonta A had two red windows to control the film advance, using each of the numbers for 6×9 twice.

The photographer loads the film into the camera, attaches the leader of the new film into the take-up spool from the old, winds on to check it's working, then closes the back and winds on until the film start marks can be seen through the window. For every frame thereafter the photographer simply winds until the next number is visible.

Cameras for non-standard formats (such as 6×7 or 6×17), as well as newer or more expensive standard-format cameras must use a different counting system. Most commonly, the photographer loads the film then winds manually until a bar or arrow on the paper is aligned with a mark on the film guides. The back is then closed, and thereafter the camera "knows" how far to wind the film.

People accustomed to the regularity of 35mm winding may at first be alarmed by how 120 film seems to need less winding as one proceeds: this results from the effective increase of the diameter of the take-up spool as more film and backing paper are wound onto it.

When taken out of the camera the film is kept coiled up by fixing it with a little adhesive strip provided by the factory. Film advance of 120 film is always unidirectional: the original spool of a film roll always becomes the take-up spool for the next film roll. Unlike cameras for 135 film, those for 120 film show a variety of directions for winding.


Frame sizes[]

Typical frame sizes
(actual sizes may differ slightly)
name nominal size frames
cm in mm on 120 on 220
6 × 4.5 56 × 44 15 or 16 32
6 × 6 2¼ × 2¼ 56 × 56 12 25
6 × 7 56 × 70 10 20
6 × 8 56 × 75 9 19
6 × 9 2¼ × 3¼ 56 × 84 8 17
6 × 10 56 × 93 7

The 120 film allows several image formats, the most common being the "6×6" (more exactly 56×56 mm) square format. It is sometimes referred to as "2¼ × 2¼" inch (or 2¼ square) format, though this is less common. Rectangular formats that are nominally 6×9 cm (120 full-frame format) and 6×4.5 cm (120 half-frame format) are also standard. Additionally 6×7 cm and less commonly 6×8 cm and 6×10 cm are used. Special-purpose panoramic cameras even produce 6×12, 6×17 cm or even wider frames. Like "6×6", all sizes are nominal; actual dimensions are a bit smaller. Among them, 6×7 and 6×4.5 enlarge almost exactly (without wasting any film) to 8×10" (inch) paper, for which reason their proponents call them ideal formats. The 645 format (6×4.5) in particular is now (2009) the smallest, lightest, and least expensive roll-film design that is widely available.

There are 16 exposures per roll for 6×4.5 format (for some cameras, only 15), twelve for 6×6, ten for 6×7, nine for 6×8 and eight for 6×9. The film is 72 cm long.

Similar 6 cm formats[]

220 film[]

220 film, introduced in 1965, is the same width as 120, but with double length (144 cm) and thus twice the number of exposures per roll. ISO 732 also specifies the dimensions of 220 film. Unlike 120, there is no backing paper behind the film itself, just a leader and a trailer. This allows a longer film on the same spool, but as a result there are no printed frame numbers for old cameras that have red window as frame indicator. (Moreover, light from the window would fog the film.) Also, since the film alone is thinner than a film with a backing paper, a differently positioned pressure plate may be required to achieve optimal focus. Some cameras capable of using both 120 and 220 film will have a two-position adjustment of the pressure plate (as well as a switch elsewhere to adjust winding), while others will require different film backs.

There is only a small choice of 220 film now (2009) available; for example, there is only one kind of black and white film (from Kodak).

The great majority of cameras for 220 film also take 120 film, but at least one model of Linhof only takes 220.

620 film[]

620 film, introduced by Kodak in 1932[1] as an alternative to 120, is essentially the same film on a slightly different, thinner, all metal spool (120 was wood cored at that time):

  • 120 spool: 2.466″ length, 0.990″ flange, 0.468″ core
  • 620 spool: 2.468″ length, 0.905″ flange, 0.280″ core

The cameras designed to use 620 film usually cannot take 120 film — although there are exceptions that take both, such as the Ilford Envoy. Most of them were made by Kodak (which, after its introduction, made few cameras for 120). 620 film was discontinued in 1995, but some photographers respool 120 film on 620 spools in the darkroom to use their 620 cameras.

105 and 117 films[]

105 film, introduced by Kodak in 1898 for its first folding camera, was the original 6×9 cm format roll film. 117 film, introduced by Kodak in 1900 for its first Brownie camera, was 6×6 cm format. These formats used the same width film as the 120, but with slightly different spools and backing paper.

Rajar No.6 film[]

Rajar was a brand name of British company APeM. Rajar No. 6 film was a 6cm roll film similar to 120, but on a spool with a square drive slot, made around the 1920s. Many cameras made for this film were converted by adding an adaptor to fit the end of 120 spools.

See also[]

Sources[]

Links[]

Advertisement